Tel No. (+86) 186-0797-1528

Pulse bag dust collector

MX-II type is on the basis of MX-I, and improved new high efficient pulse bag dust collector. New type pulse bag dust collector retained the high purification efficiency, the ability to deal with gas, stable performance, convenient operation, long service life of filter pocket, low maintenance workload, etc. And reform the structure and pulse valve; solve the outdoor placement and low pressure of compressed air source.

Our factory produced MX-II type pulse bag dust collector was authenticated by upper leading office and national scientific research departments. This kind of filter is improved a lot, has features of advanced and reasonable in structure, low injection pressure, good deashing, low maintenance workload. It is more ideal pulse bad dust collector.

Dust collector working principle:

Gas contained dust is from dust collector air inlet into middle and lower box, through the process of filter bag into upper box, due to various effect of filter bad, gas and dust is separation, dust is adsorbed on the filter bad, and gas is through filter bag then venture tubes into upper box, out of air outlet. With the increase of time, more and more dust attached to the filter bag, therefore make the resistance of the filter bag is gradually increased, and the gas through filter bag is gradually reduced, in order to make dust collector work properly, the resistance of filter should be controlled in the specified range (usually is 120-150 millimeter of water). When resistance is increased in the specified range, controller issues instructions to trigger every control valve and open pulse valve in order, compressed air of air bags is through injection pipe then venture tube and jet into the corresponding filter bag, filter bag is swelling rapidly under the reverse effect of instant air flow, make dust fall off the surface of filter bag, filter bag can be reused. The dust fall into ash hopper and discharge out by ash discharging system, due to the dust adsorbed on the filter bag is removed regularly, purified gas get through normally, make sure the dust collector work normally.

pulse bag dust collector (4)

Model No.  Filter area Air volume Inlet concentration Filtration velocity Runing resistance Outlet concentration Compressed gas consumption Filter bag specification Filter bag Weight
  m2 m3/h g/m3 m/min Pa mg/m3 m3/min   pcs t
MX-20 20 1200-2400   1—2 800~1800 <100 0.1 Ø126X2000 24 0.7
MX- 24 24 1440-2880     800~1800 <100 0.1 32 0.9
MX- 28 28 1700-3500   800~1800 <100 0.1 36 1.3
MX-32 32 2880-4800 <1000 1.5—2.5 800~1800 <100 0.13 42 1.6
MX-38 38 3400-5700 <1000 1.5—2.5 800~1800 <100 0.15 48 1.8
MX-48 48 4320-7200 <1000 1.5—2.5 800~1800 <100 0.2 64 2
MX-60 60 5400-9000 <1000 1.5—2.5 800~1800 <100 0.24 80 2.5
MX-72 72 6480-10800 <1000 1.5—2.5 800~1800 <100 0.3 96 3
MX-95 95 8550-14250 <1000 1.5—2.5 800~1800 <100 0.38 120 4
MX-130 130 11700-19500 <1000 1.5—2.5 800~1800 <100 0.52 160 4.7
MX-160 160 14400-24000 <1000 1.5—2.5 800~1800 <100 0.57 200 5.4
MX-190 190 17100-28500 <1000 1.5—2.5 800~1800 <100 0.62 240 6.5
MX-220 220 19800--33000 <1000 1.5—2.5 800~1800 <100 0.66 280 7.7
MX-250 250 22500-37500 <1000 1.5—2.5 800~1800 <100 0.75 320 8.6
Top